-
To design
Humidification System for Production
Laboratory I and Production Laboratory
II of Department of Textile Engineering,
NED University of Engineering &
Technology, Karachi.
-
To design
a Co-generation Plant for spinning unit.
a) Most of the spinning units have their
own power generation plants.
b) The hot flue gases evolve from power
generation has temperature of 850o C
approx. can be used:
This
steam can be used for absorption
chilling which can further be used for
air conditioning.Chilling can be used
for cone conditioning / vacuum
conditioning
-
To design
and fabricate an apparatus to perform
Impact penetration and Spray Rating
tests.
a) These tests are performed to test the
water penetration or repellency in
fabrics chemically finished by Water
resistant chemicals.
b) Impact Penetration Test and Spray Rating
Test are performed on different
apparatus.
c) Designing and fabrication of apparatus
so that both above mentioned tests would
be performed on same equipment.
-
To design
a bleaching range for the processing of
woven, knitted and terry fabrics.
a) Bleaching ranges already exist are
specified for one type of fabric only
i.e. knitted or terry or woven fabric
b) This project will help students to
understand not only the mechanism of
various machines to carry out same
processes in different manner but also
enable them to design alternative
machinery range to enhance the
efficiency, affectivity and cost-quality
compatibility.
c) Figure-out alteration or any special
mechanism/device required for woven,
knitted or terry fabric.
d) Detailed study of different Bleaching
ranges that should include the machine
mechanism, process chemistry and power
transmission.
-
To
design cold sizing machine.
a) In this method, there is no
need for sizing preparation, size
boxes, pre wetting, cooking tanks
etc. Special wax is applied so that
warp yarn withstand the stresses
of loom during weaving.
b) Also cost saving and require
only hot water treatment to remove
cold size or wax during pre –
treatment. Conventional de-sizing
doesn’t require.
-
To design a weft straightening
system for fabric having S bow
after printing.
a) This project is already
conducted last year by the final
year students of batch: 2002-03.
Improvement and complete drawings of
design is required along with
simulation of proposed model.
-
Design of a Heat Recovery System for
Stenter.
a) Gases at high temperature
are exhausted from stenter can be
utilized in heating gas before
entering in burners of stenter.
b) It will reduce energy
consumption of stenter burner and
improve its efficiency.
-
To
analyze major processing faults and
re - design vacuum slot of Bleaching
Machine to reduce the faults during
the processing of wider width and
heavy quality fabrics.
a) Vacuum Slot or Vacuum pump
for fluff extraction from the
bleaching chamber doesn’t work while
processing fabrics of wider width
and high GSM.
b) Re – designing of existing
system so that it could work for
heavy GSM fabrics with the same
efficiency so as for low GSM Fabircs.
-
Process Re-Engineering of a Denim
Garment unit using FMEA technique to
increase the productivity.
a. FMEA stands for Failure Mode and
Effect Analysis.
It
will include analysis of the
complete denim processing from
Spinning to Garment Finishing.
-
To design
and fabricate the automated color
dispensing system for the colour kitchen
of printing department.
-
Investigation of the reasons of yarn
imperfections and design a system to
identify the faults on a ring spinning
frame.